From: matt (mkaake_at_gmail.com)
Date: Tue Nov 23 2004 - 05:29:31 PST
Lol... can't argue with that.
I think that most of my problems were around DHCP not properly
configuring. I was looking at the IP that I was putting in for my
computer, when I realized that it didn't make any sense as far as my
router was concerned, so I did a nice hard reset on the router, and
now it's assigning IP's normally. I've now been able to connect to
Escale via TCP/IP, but I still can't quite seem to get it to print.
It's really frustrating, as I know that I'm this >< close to getting
it to print properly, but I don't have the time right now to try to
figure out what's going on.
So I guess printing will just have to wait for a while. Sadly. Maybe
in another week or two...
Matt
On Mon, 22 Nov 2004 15:26:31 -0500, David Abramowitz
<david.abramowitz_at_verizon.net> wrote:
> On Nov 22, 2004, at 2:32 PM, David Neale wrote:
>
> > Matt, you have my sympathy. I, too, have tried and failed to get an
> > MP2100 to connect to a Mac with anything other than a serial cable.
> <snip>
>
> There is no try, only do.
>
> Sorry, couldn't resist - the kids were watching Spaceballs yesterday,
> and that Yogurt guy...
>
>
>
> --
> This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
> Official Newton FAQ: http://www.chuma.org/newton/faq/
> WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
>
>
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Tue Nov 23 2004 - 12:30:01 PST