From: Woody Smith (woody_at_bitstream.net)
Date: Mon Dec 15 2003 - 15:30:33 PST
Marty
I used a 220 garnet paper to smooth the rough edges then a 3M 360
freecut to smooth the scratches. The second paper has a lubricant that
leaves a light colored residue. I used this as a guide to reveal where
the case needed to be reduced. I doubt that the fine powder is a
problem but I still used compressed air to blow it out of the battery
slot and off the battery when done.
Woody
On Monday, December 15, 2003, at 12:42 PM, Martin Joseph wrote:
>
> On Monday, December 15, 2003, at 04:53 AM, Woody Smith wrote:
>
>> I plugged my rebuilt battery pack in last night and it charged without
>> a problem. Doesn't look bad either.
>
> Mine doesn't look that great. It still a little snugger then I would
> like too.
>
> Perhaps a bit more sanding to make it looser.
>
> I think the next time I will try Frank's case cracking approach.
>
> Marty
>
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Mon Dec 15 2003 - 16:00:01 PST