From: Paul Curtis (MicroSSG_at_Comcast.net)
Date: Tue Dec 09 2003 - 22:42:21 PST
Paul Curtis wrote:
>OK,
>
>Comm1 is set to 9600,8,n,1 - flow control none, FIFO is disabled on my
>
These are the device manager settings, right?! [Correct - this is my
laptop running XP]
>the MP 120 and tapped extras, tapped connection, made sure that "Serial
>9600 - Windows" was selected, then tapped connect. It blips it's
>
So what are your NCU settings for the serial port? [NCU is set to Comm1
- Baud 9600]
If there isn't the same setting as for the newt (you're using 9600,
why? [Trying the base speed to increase the chance for working]) the
connection will fail.
Manu
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/ -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Tue Dec 09 2003 - 23:00:00 PST