From: Paul Curtis (MicroSSG_at_Comcast.net)
Date: Tue Dec 09 2003 - 15:30:00 PST
Ahhh, that was dumb, yes I had NCU open... So I shut it down and when I
send data the TX light blips once from HT.
Regards,
Paul Curtis
-----Original Message-----
From: newtontalk-bounce_at_newtontalk.net
[mailto:newtontalk-bounce_at_newtontalk.net] On Behalf Of Andrei Chichak
Sent: Tuesday, December 09, 2003 2:52 PM
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] Newbie question about transferring data from one
Newt to another...
At 02:38 PM 12/9/2003 -0800, you wrote:
>OK, I started HT and configured for Comm1, when I hit a key I get an
>error message that another device is using the port, wait until that
>device is done, close HT and restart. I did that and get the same
>message. The MP 120 was turned off the whole time.
Did you shut down the newton connection software? It would have the port
open and the OS would tell HT to go away, it's busy. Actually any other
program that has com1 open would give you the same result. This would
also
explain why you can't connect, someone else has the port. Check for
another
process running.
A
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/ -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Tue Dec 09 2003 - 16:00:01 PST