From: Paul Curtis (MicroSSG_at_Comcast.net)
Date: Mon Dec 08 2003 - 11:29:22 PST
OK, I have a USB to Serial adapter and connected. I installed the NCU
from the links below, configured the NCU software to use Comm 1 - which
is what the USB-Serial port is and nothing...
On the MP 120 I tap the extras, connection, Serial 9600 - Windows, and I
get the error "The connection was stopped because there was no
response".
I feel like Charlie Brown after Lucy pulls the football away at the last
second! HELP!
Other notes, I had to manipulate the System.ini file to include the
C:\Newton\TSIVID.386 reference, which is also where that file is and I
re-booted. I also turned on all of the comm ports inside NCU to see if
that helped, but no.
I'm pretty sure I followed all of the instructions properly, any ideas?
Regards,
Paul Curtis
MP 120/130/2100
-----Original Message-----
From: newtontalk-bounce_at_newtontalk.net
[mailto:newtontalk-bounce_at_newtontalk.net] On Behalf Of NewtonGuy
Sent: Thursday, December 04, 2003 2:49 PM
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] Newbie question about transferring data from one
Newt to another...
Mac
<http://www.unna.org/unna/apple/connection_utils/ForMac/
NewtonConnectionUtilities/NCU1.0Installer.sit>
Windows
<http://www.unna.org/unna/apple/connection_utils/ForPC/
NewtonConnectionUtilites/NCU%2095-NT.exe>
On Dec 4, 2003, at 4:18 PM, Paul Curtis wrote:
> I might have a problem here, I have the NCU floppy, but my laptop only
> has USB ports, so I have no way to connect my Newt to it...
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/ -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Tue Dec 09 2003 - 13:00:01 PST