From: Paul Curtis (MicroSSG_at_Comcast.net)
Date: Thu Dec 04 2003 - 14:01:05 PST
Fellow Newts,
This seems like it should be simple, but I'm managing to make it
difficult.
I have a MP 120 v2.0 with contacts I want to move to a "new" MP 130
v2.0.
I tried this: selected all contacts on the 120 and beamed to the 130,
after the first contact has been transferred the operation stops and I
get a beam error # 48402. Then after aborting the attempt, the 120
refuses to quit trying the beam (I get the growing star at the top of
the screen), and when I try to turn it off it says something like, "are
you sure you want to interrupt the communication" to which I ok, with no
luck. So I reset the 120.
I also tried using my Newton serial cable to directly connect the two,
but that doesn't work either.
Any help is greatly appreciated!
Regards,
Paul Curtis
MP 120/130/2100
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Thu Dec 04 2003 - 14:30:00 PST