In a previous message, victor_at_newtontalk.net typed vigorously:
>Hrm. I suspect that there's something about our 10/100 switches that causes
>the card to either autodetect incorrectly the first time, or try one setting,
>and if there's an error then close the connection and try another. This
>might confuse the Newton driver if it expects the card to be linked to the
>network by a certain point and the card is trying to drop and re-enable the
>link. Unfortunately, looking at 3Com's diagnostic and setting software
>for this card, there doesn't seem to be a way to "hard-code" the card in
>either full or half duplex mode.
FWIW, I use a Farallon card in my 2100 to connect up to a Netgear FS510T
auto-sensing 10/100 switch. I have never run into any connection issues
whatsoever. I'm using a static IP address rather than DHCP for the Newton.
g.
......................................................................
Grant Hutchinson Interface Considerations & Toys
Live video served fresh since 1996. http://www.splorp.com/cam/
Now fortified with daily ramblings. http://www.splorp.com/blog/
Newton. It's the Palm with a brain. http://www.splorp.com/newton/
Online community web site handyman. http://www.newted.net/
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.chuma.org/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net/
This archive was generated by hypermail 2.1.2 : Thu Aug 01 2002 - 06:03:30 EDT