"T.M. Camp" wrote:
>
You can try a small flat head screw driver and super glue it to the
screw head.
Rodney
> I also pulled off the back to see how the wires came through to the
> motherboard (fortunately I had a Torx-10 as well). But I can't get any
> further because the screws holding the board in place are factory tight and
> I stripped one of them accidentally.
>
> Any advice on how to remove/loosen it? I'd like to run the new wire through
> without having to poke it from the top and wiggle it around for hours in the
> hope it finds the right passage through to the other side.
>
> Thanks,
>
> T.M. Camp
> ---------
> data: tmc_at_tmcamp.com
> url: http://www.tmcamp.com
>
> --
> Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html
> Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/
> This is the NewtonTalk mailing list - http://www.newtontalk.net
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Thu Aug 01 2002 - 06:02:52 EDT