Hi Folks,
Uhh, on my 2000U the door has a little spring loaded tab slider thing
on it that you can slide to retract one of the pins on the hinge, thus
allowing you to remove the door without taking the newton apart. It's
on the small part of the door, and is against the newton when the door
is closed. Or, am I the only person who's Newton has this feature?
Forgive me for pointing out the obvious. :P
Hans
On Saturday, July 6, 2002, at 03:17 AM, Joel M. Sciamma wrote:
>
> Dan,
>
>> I just got a port door for my 2100 and looking at it, I assume I have
>> to
>> take apart the newt to install this? And to all who have done
>> this.....any
>> tips? Thanks in advance.
>
> Unfortunately you have to go all the way and remove (or just loosen) the
> screen sub-assembly so you can slip the door posts into their slots.
>
> Take advantage of this strip-down to clean as you go, check the touch
> screen
> contacts are clean (and use a contact cleaner) and clean out the gunk
> that
> accumulates in the microphone and the speaker. Check there is no dirt
> under
> the screen bezel and on the edges of the screen itself.
>
> Use some gentle compressed air from a can to blow out any dust from the
> boards and connectors.
>
> Ideally, use an eathing strap while handling the electronics.
>
> Joel.
>
>
> --
> Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html
> Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/
> This is the NewtonTalk mailing list - http://www.newtontalk.net
>
>
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Thu Aug 01 2002 - 06:02:09 EDT