OK I'm a newbie, still trying to figure out this Newton thingie. My wife
has an eMate and I set her up with ethernet. I've
been running a Pilot 1000.
Now I've got an upgraded 2000 and I installed PQ 1.2r2 (from UNNA). I
put PQC (also from UNNA) on my Mac 7200/90
where I am also running Quicken 98. PQC runs fine on serial, but I don't
see any other options, and I see in the Guide
that you can't use PQC over a port that is on LocalTalk.
Is there a hack to run PQC over ethernet? If I switch to Money, can I
run that over ethernet?
Also, is there any way to import my Mac Appleworks spreadsheets onto
QuickFigure Works? I got an original
QuickFigure Pro 3.0.4 disk with my Newt but it has a corrupted file and
no manual. If I figure out how to install this can I
import spreadsheets? Can I run QFP on NOS 2.0 or 1.3?
Thanks!!
Owen
-- This is the Newtontalk mailinglist - http://www.newtontalk.net To unsubscribe or manage: visit the above link or mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe
This archive was generated by hypermail 2.1.2 : Wed Jan 02 2002 - 12:01:18 EST