>I have what's probably a dumb question. I just got a 3Com 3CXE589DT network
>card (x-jack) and when I insert it into my MP2100, I get an error (cannot
>recognize this kind of card). Any ideas? I have the farralon and 3com
>drivers installed and they worked fine with my older Farallon 589
>(etherwave) card.
>
>any ideas appreciated.
>
>-Hal
I have the same card and would get the same error message. The key is
the NIE 2 instructions follow those first then Chuma Ethernet
instructions.
I got my card working by first unistalling all related ethernet stuff
and card drivers. I then installed in this order.
inetstup.pkg
inetenbl.pkg
loctsup.pkg
newtdev.pkg
enetsup.pkg
FarallonEthernet.pkg
3comaddon.pkg
3c589.pkg
Under my Preferences I set Appletalk as follows:
Connect using EtherTalk
Card 3Com 3C589 D PC Card
I do not know why I can not use the driver for Megahertz 589DT. There
is hope. Other driver setups may work, but once I got it working I
stopped experimenting.
Enjoy the speed of Ethernet!
-- Mike Drabicki WhizBang! Visuals www.whizbangvisuals.comYell. Jump. Play. Out-run those sons-of-bitches. They'll never live the way you live. Go do it. --Ray Bradbury, Zen in the Art of Writing
-- This is the Newtontalk mailinglist - http://www.newtontalk.net To unsubscribe or manage: visit the above link or mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe
This archive was generated by hypermail 2.1.2 : Wed Jan 02 2002 - 12:01:16 EST